Fishing with Rod Discussion Forum

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Is my rod good enough for sockeye fishing?  (Read 15566 times)

wjlz

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 35
Is my rod good enough for sockeye fishing?
« on: September 25, 2025, 08:51:02 PM »
Hi all,

I know sockeye fishing is over for this year. I am prepare for the next time.
I have a rod: 10ft, med power, med-fast action, line weight 15-30Lb, lure weight 3/8 - 1 3/8.
Can I use it the cast 3 ounce sinker?

Any info would be appreciated. Thanks in advance.
Logged

Darko

  • Old Timer
  • *****
  • Offline Offline
  • Posts: 694
Re: Is my rod good enough for sockeye fishing?
« Reply #1 on: September 25, 2025, 09:21:31 PM »
yes it's pretty good. As long as you load the weight properly while you cast you'll be fine. On most rods you can easily cast much heavier weights than it says as long as you're careful.
Logged
if you ain't fishin, you ain't livin

RalphH

  • Old Timer
  • *****
  • Offline Offline
  • Posts: 5453
    • Imitating Salmon Fry
Re: Is my rod good enough for sockeye fishing?
« Reply #2 on: September 26, 2025, 07:55:54 AM »
sounds perfect. Line and weight recommendations are general guides. Line is for mono. For flossing the Fraser you should use braid of a about 65lbs. When I did that stuff I used a couple of rods with similar ratings and had no issues even with springs
Logged