Check fish wizard for the stocking, see what they have been doing the last few years for stocking times.  I usually fish it during the spring.  Never tries it in the fall.  I fished buntzen in the fall more.

Last time I was headed out from Buntzen,  just left of the dog park/beach area there were quite a few rises.  I wish I had time to tie on a dry fly.  This I believe was back in June as the sun set over the hills.

TtotheE,

Being a newcomer to fishing in general, my understanding is that using a dry fly requires a fly rod/reel/line combination.  Since I don't have this, "tying on a dry fly" would be something I can't do.  Am I right?

Actually,  I've done the following:

Used a wooden float,  the kind that balances itself and has enough weight to cast out on its own.  Tie on a leader as fine as  you dare.  For hatcheries 2-4# should do fine.  Then tie on the dry,  lots of floatant.  After you cast out,  carefully reel in your line so your main line,  float,  and dry fly are in a straight line and patiently wait for the wake to dissapear.  Usually just keeping the dry there should work,  otherwise giving it the slightest twitch every so often works too to get the trout's attention.

Also,  I'm sure Otto has used his long pole to the same effect.

I personally enjoy watching my fly line roll out infront of me,  when trying to present the fly properly.  Doesn't mean other methods won't work  

Well, that stopper knot did the trick.  I think I've got my setup right the way it should be now.  I was out there last night, had bait in the water for nearly four hours, and not a single bite.  There were at least four other fishermen around, and I didn't see any fish reeled in.  I'm thinking that this might not be the best time of year for Sasamat.

I'm thinking to try Buntzen instead, but I dunno if it will be any better.  Does anyone have any suggestions for lakes to try in the Burnaby vicinity that might be productive this time of year?

I've only rigged up a spinning outfit with a fly on the end about three times,  so I'm no expert on the floats.  The float I have has 2 rings where you can tie your mainline,  and your leader to.  Unlike the foam floats alot of people use on the Vedder or Stave,  it does not slide so you can't set the length.  I'm sure there are other types however,  somebody who has more experience with floats may be able to help you out.

The leader length should be short enough so that you can cast comfortably,  and long enough so that the float isn't too close to the fly.  A couple of feet should suffice.

Zaphod, you have a PM