Fishing with Rod Discussion Forum

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Re-shaping cork on a built rod  (Read 2178 times)

DanL

  • Old Timer
  • *****
  • Offline Offline
  • Posts: 566
Re-shaping cork on a built rod
« on: July 25, 2019, 05:24:14 PM »

I have a couple off the shelf factory rods where I'm thinking of trying to slightly re-shape the cork. The top end is flared and I would like to change it to a more tapered cigar shape. I'm planning on sanding it down manually with sandpaper and just going slow and taking my time. I might have an un-repairable busted rod to practice on first.

Has anyone tried doing this and have any tips/advice?
Logged

Rieber

  • Old Timer
  • *****
  • Offline Offline
  • Posts: 1443
Re: Re-shaping cork on a built rod
« Reply #1 on: July 29, 2019, 08:37:38 AM »

I tried to do it by hand before and it was tedious work. You can certainly do it but I found that soon as I got into it I wished I never started. since I don't have three hands, I found this to be a quick way to ruin my satisfaction with a nice rod. clamping in a vise and then using strips of sand paper with both hands to sand around the handle - I just found it miserable. I've seen example of some nicely reshaped handles but I'll never do this again.

Since then I've done this a couple times on a metal lathe with a through-hole headstock. Wrap the blank with paper towel and carefully clamp the shaft in the three-jaw chuck. It would be so easy to crush the shaft so finesse is critical. Then it's an easy process to sand and true the entire handle to that clamping position. Clamp as close to the handle as possible to reduce wobble. On long handles - drift rods and spey, I'll turn a centerbit into the butt end so I can use the tailstock for support. Nice to have a less wobbly handle to sand. Then it's a simple plug repair afterwards - provided it didn't have a decorative metal butt plug/cap. Moderately slow speed and light sanding pressure does nice work.

I've cleaned up soiled and slippery handles like this as well. Fortunately I have access to a suitable lathe.
Logged

Dave

  • Old Timer
  • *****
  • Online Online
  • Posts: 3192
Re: Re-shaping cork on a built rod
« Reply #2 on: July 29, 2019, 11:03:36 AM »

What Rieiber said. If you can turn the rod the results will be much better.
Logged