Fishing with Rod Discussion Forum

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Fly rod repair question  (Read 4029 times)

boscheefish

  • Full Member
  • ***
  • Offline Offline
  • Posts: 63
Fly rod repair question
« on: February 07, 2012, 04:58:34 PM »

I am going to attempt to attach 3 eyelets on my fly rod that have come off,
My only question is...is a standard epoxy going to be ok or does it need to be flexible epoxy?
Cheers!
Logged
long live the vedder

typhoon

  • Old Timer
  • *****
  • Offline Offline
  • Posts: 1326
Re: Fly rod repair question
« Reply #1 on: February 07, 2012, 05:11:50 PM »

You also need to wrap thread to hold the guides on. This is more complicated to do by hand than just epoxy work. I recommend getting a shop or one of the sponsors here to do it for you if you haven't done it before.

You need flexible epoxy. Standard epoxy is too hard and will crack and break almost instantly.
Many fly shops sell FlexCoat or other rod building epoxy. You can apply a thin coat with a brush with the rod sitting horizontal. Then turn the rod 90 degrees every 20 minutes for 2 hours.
Logged

Valley Custom Rods

  • Valley Custom Rods
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 23
  • Valley Custom Rods
    • Valley Custom Rods
Re: Fly rod repair question
« Reply #2 on: February 07, 2012, 06:55:07 PM »

I am going to attempt to attach 3 eyelets on my fly rod that have come off,
My only question is...is a standard epoxy going to be ok or does it need to be flexible epoxy?
Cheers!

Hi boscheefish,
If you would like to pop by the shop some time I would be happy to show how to wrap them them up.  Email me anytime if I can help.
Regards,
Mark
Logged