Fishing with Rod Discussion Forum

Fishing in British Columbia => General Discussion => Topic started by: andy diersch on April 23, 2013, 08:10:50 PM

Title: how to cast ???
Post by: andy diersch on April 23, 2013, 08:10:50 PM

Ok you guys now that I have the proper equipment thanks to your valuable information, i need a little help in setting up my rod and a few tips on how to properly cast this setup. Just beginning and could use a little info thanks in advance

Title: Re: how to cast ???
Post by: leapin' tyee on April 23, 2013, 08:45:09 PM

What kind of set up do you have ?
(FLy, Spey, Baitcast,Spinning,or Centerpin ETC...)

Title: Re: how to cast ???
Post by: troutbreath on April 23, 2013, 09:24:23 PM

http://www.youtube.com/watch?v=_ZegpugUNHI


Although I don't cast like that. ::)

Title: Re: how to cast ???
Post by: alhambra on April 24, 2013, 09:39:28 AM

Well, you can ask for couple of lessons, if you value your time and do not want to waste it on the water.

Title: Re: how to cast ???
Post by: firstlight on April 24, 2013, 10:00:01 AM

Just watch a couple of these videos and is all you will need.

http://www.youtube.com/watch?v=1Db6moaCuk8

Title: Re: how to cast ???
Post by: obie1fish on April 24, 2013, 10:59:50 AM

Videos are good as they show good habits and, if you're lucky, are well-worded. The difficulty lies in translating the process from visual (watching the video) to kinaesthetic (actually performing the casting motion).
The most important part of the video is the guy beside the caster. No number of great videos can replace a teacher at your side while the fly rod is in your hand. Video taping yourself casting can help you correct mistakes as well.
Also, start with short casts with lots of room around you, either on still water or a large patch of lawn such as a school field. Clip the bend off a wrecked fly you no longer use and tie it on the end. That keeps things safe and helps your cast to naturally unfurl.
And, most importantly, have patience with yourself. Good luck!